Rusty Bowtie
General Category => General Discussion - Intros => Topic started by: EDNY on November 06, 2017, 11:46:16 AM
-
Tom...trying to mock up a set of fiberglass fenders on my channeled/raked 33 Master...can you give me the approx outer distance the front fenders are from the body near the door hinge. Approx is all I need.
-
Ed...photo of mine...might help..roughly 14.25 inches ...as you see where I put the tape end....I also have running board off on drivers side of you need measurement from frame to end of fender...
-
OK looking at your measurement if you moved the tape up to the door skin it would be in the 13" range...that's about where I'm at. Fitting a set of fiberglass fenders to my 33M project. The car is channeled and raked so the front end drops down into the fenders ...plus I extended the hood by 5" and laid the radiator back. Increased the wheelbase requiring me to lengthen the running boards at some point. Will most likely cut a couple of inches off the bottom of the doors to allow mounting the running boards higher...my Winter project.
-
Ed,
Here's what I got on mine.
Tom
-
Thanks Tom...I'm in the range I need to be.