Rusty Bowtie

General Category => General Discussion - Intros => Topic started by: ghost28 on April 29, 2017, 08:09:44 PM

Title: E.M.S sheet metal is proud of there parts. WOW
Post by: ghost28 on April 29, 2017, 08:09:44 PM

I just bought a tail pan for a 35 cherolet master, YIKES  350.00. I understand there is a lot of work to make one with the edge shrining and english and bead rolling. I did just recieve the part and they use a good 18 guage metal and the crafsmanship of the part is amazing. Pay to play I guess. The part is nice though.

Title: Re: E.M.S sheet metal is proud of there parts. WOW
Post by: TFoch on April 29, 2017, 09:00:30 PM

Any pics?   :o

Title: Re: E.M.S sheet metal is proud of there parts. WOW
Post by: ghost28 on April 29, 2017, 09:13:43 PM

Quote from: TFoch on April 29, 2017, 09:00:30 PM

Any pics?   :o

  Not today it's been snowing all day and believe it or not the shop is getting real crowded. When I work on something it's all on wheels so I roll it outside anymore.

Title: Re: E.M.S sheet metal is proud of there parts. WOW
Post by: ghost28 on April 29, 2017, 09:19:02 PM

Here ya o

Title: Re: E.M.S sheet metal is proud of there parts. WOW
Post by: TFoch on April 29, 2017, 09:21:10 PM

Wow looks like a nice piece.  You get what you pay for!

Title: Re: E.M.S sheet metal is proud of there parts. WOW
Post by: 62131 on April 29, 2017, 09:25:57 PM

I've purchased several panels from them  they do have some good stuff

Title: Re: E.M.S sheet metal is proud of there parts. WOW
Post by: FATnLOW on April 29, 2017, 10:27:24 PM

a few years back did the rear pan on  a '36 that I had bought...  EMS  pan was  a good fit