General Category > Wood & Framing Section
wood skeleton blue prints?
billy:
does such a thing exist?
i know that if i had the drawings and measurements i could make the wooden parts.
i see the kits and the astronomical prices that go with them.
i am not looking to make them for money.
but i am a member of the low flyers c.c. and am affiliated with 4 other clubs.
and i must know 10 different guys that are struggling to restore /repair their cars working from splinters.
TFoch:
I haven't seen any drawings, just images of the assemblies and some of the components.
ghost28:
When I first started working on all of these termite ridden cars and replacing the wood with steel I should have made blueprints of each one, but I usually just flew by the seat of my pants and didn't think any one else would build one of these cars. Who knew?
themoose:
According to VCCA there are no wood patterns available. They do recommend two suppliers of wood components but I don't know how expensive they are.
http://autowood.net/index.htm Jim Rodman at 219-797-3775
David Entler rd #2 box 479c,Glen Rock,Pa. 17327 phone 717-235-2112 cell 717-968-2751 His bussiness is called David J. Entler Restorations
Moose
billy:
--- Quote from: themoose on February 11, 2013, 09:00:31 AM ---According to VCCA there are no wood patterns available. They do recommend two suppliers of wood components but I don't know how expensive they are.
http://autowood.net/index.htm Jim Rodman at 219-797-3775
David Entler rd #2 box 479c,Glen Rock,Pa. 17327 phone 717-235-2112 cell 717-968-2751 His bussiness is called David J. Entler Restorations
Moose
--- End quote ---
if a guy was motivated and had the time and money up front.
he could buy one of each of those kits and use them for patterns to make multiples.
Navigation
[0] Message Index
[#] Next page
Go to full version