Rusty Bowtie
General Category => Early Chevy/GM Discussion => Topic started by: 35chevyroadster on May 22, 2015, 11:05:28 PM
-
Hello I need the distance for the top of quarter panels from side to side at the doors . There isn't any wood left in body so I have no way to get it correct to put metal in body. Thanks For any help. Hot Springs AR
-
What can you tell me about your roadster, do you know whether its a 34 standard or a 35 standard .
Is it an American body panels stamping or is it an Australian body, made by HOLDEN GM. ?
mike lynch
-
wood door post rear to door post rear ,measured across 49 25/32" say the factory blueprint
My body is completely disassembled so cannot supply the measurement you need.
Hopefully by sept 2015 I will have the quarters attached top the door posts.
Working on the frame filling holes and getting ready to use dummy block for motor mount placement and also trans mount for t56 tremec magnum
mike
-
The roadster is a 35 cowl vent opens a rear ? It has a left hand drive dash ,american ? Car was in New Mexico.Thanks for the measurements.
-
By the way, I have only ever seen pictures of one 34-35 standard roadster in north America made into a street rod. Its was a picture at the LA roadsters show online from about 2 years ago, car was blue with black fenders with gary McLean chrome wire wheels.
I also am building a street rod.
Only phaeton I know about was wes rydells 35 , the grand national roadster show, Americas most beautiful roadster winner of 2014.
mike
-
Some pictures of 1935 chevy master frame with mustang 11 front end and chevy s10 rear 4x4