Well I got my 4L60E rebuilt and was trying to install the torque converter as instructed, turn and twist until it sets three clicks. I did this and eventually got it installed where it felt seated. The videos I looked at all said to mount the trans to the block and then line up the converter bolt holes with the fly wheel first by spinning the converter by hand to line up and install the first bolt and then rotate the engine to line up the other two. The problem is the converter will not spin. I took it back down and removed the converter and reinstalled to see if I did something wrong. When I get the converter in to where I think it should be, it will not turn. Any guidance is greatly appreciated, thanks.