Finishing up the LT1 swap in the 37 sedan. The 95 donor Camaro drive shaft is about 1-1/4" to 1-1/2" too short. If I can install a longer slip yoke like the one in the picture...could be good to go.
In the picture the top yoke is the 95 Camaro..it is 3.5" long which is 1.5" shorter than the one below it. The lower yoke is one I had laying around...it has outside snap rings.
The upper yoke uses inside rings and the caps are "slightly" larger in diameter.
Do I need to locate a longer slide yoke with inside lock rings?
Ed
FYI: Yoke is 27 spline, stock drive shaft is 41.5" center to center of U-joint caps...need approx a 43" shaft. In case anyone has parts to sell.