Yep, that's why I'm stopping for now Mike. I was trying to route it with out cuting up the original Corvette column hanger. The engine, trans, floor pan, firewall is 3.5" higher and 10.5" futher back from where they were located in the Vette. So when I get back to it...... cut cut cut !Are you feeling good and back to normal Mike?
Ed I thought about that the other day. Pulled a couple gears out of my pile, it would be a very short chain. @ $600 I sure ain't buying one.
Well the shops all settled and my ribs healed up it's back to work. Got my w/s wiper motors relocated and the old holes filled. Cut the sheet metal out for the new header panel and rolled using my high dollar bending pipes . Test fit to mark access holes for the w/motors, flanged and then made the covers. Barely got it welded up (very crappie looking welds), I can only work over my head for a few mins at a time. Welds ground and covers back on.Now maybe after a nap, I'll try to figure out how to cut/fit the rear top section of the 2dr sedan to make the rear inner panel. Then I'll build the sides (from front header to rear) If that works i'll be able to just make the center a bow headliner.
Stats Of Website