Not knowing where to put this ,I decided this would be the place. I have scoured many sites over the last 20 or 30 years and seen lots of ideas. I have an idea kicking around in the back of my head and i would like to let it out I would like some opinions.
This is about all the 48/49/50/51 chevy trucks that have been placed on chevy S10 and gmc jimmy.frames
Now how about placing the 32/33 chevy body on such a frame. Is it to high, Is it to long , Is it to wide.The one i am sitting looking at is a jimmy 1992 4 wheel drive v8 700R4 auto,Great running little truck with leather bucked seats and auto push button 4 wheel drive,and a rear leather seat that looks like it would double as a rumble seat lol lol OK
So after going all over the map...back to the OP's question.
My stepson has a 51 GMC frame (two in fact), both 4WD. Just by looking at it I would have to say it is too wide, too long etc. But like anything else, it could always be fixed. The depth of the frame section itself is also considerably deeper than the earlier Chevy's. Once he gets all the brackets off the second frame that he wants, we are going to cut the frame up into flat stock, and I will use some of it to box the frame on my '35.
Was your plan to make it a 4WD vehicle? If so, that would be one way to do it. Just be ready to do some considerable modification to the frame. Might be a bit of work, but probably not that bad once you get at it.