Rusty Bowtie
General Category => Early Chevy/GM Discussion => Topic started by: FATnLOW on February 23, 2017, 05:31:57 PM
-
A guy met on a car site ... He is working on a '35 Chevy..... Seats he is installing are from 2006 Grand Am 2- dr sedan...doesn't look like he cut the rear down at all.........what you think???? He supplied me his measurements Wheel well to wheel well 45 inches and window to window 51 inches...measured my '33 and I came up with the same
-
They look to fit good. Thanks for the info since I have A 35 in my shop.
-
Is that window to window 51" measurement at the center or rear of the doors?
-
62131......center to center of rear window(my garnish moulding is attached) measured below them....actual measured 51 9/16" ww to ww actual 45 5/8" measured at inner reveal line (stamping area)
-
The seats fit very nice, I'm thinking those measurement are close to my 32. I'm going to check next trip to the garage I have set of seats out of a Lumina I feel they are little to big they measure about 22" across the bottom cushion at the widest point
-
I like the rear seat for the simple fact they fold down and if I get all the hardware for the back and make it work correctly...maybe I can have a storage space for a donut tire and other items ???? hopefully...no trunk on this car 62131.... I have a set of Grand Am and they measure 21" ....always been a problem on front seat unless you cut them down...
-
I've looked at he second row seat in a Dodge caravan can't remember the year,and I'm thinking it measured like 38" if a person wanted a bench seat
-
I had a S10 bench that was abandoned at my work. I brought it home and couldn't find anyone that wanted it. Measured in at 51" width.
Sadly it got thrown away.