Classified - PARTS For Sale - Wanted > 1940's later Chevy/GM PARTS Wanted/For Sale
need flywheel
trbomax:
i need a 454 external bal std shift flywheel. Must have a good gear and face,no heat cracked junk.
EDNY:
By chance would you have a part number?
Ed
trbomax:
No #. The 2 motors I have are early 70's pickup truck,q-jet carb, but they were autos. It will be a starting point for the 28 chev build. I will be useing the bell housing and 4 spd t-10 that was behind the sb because its a truck,open bottom set up for hyd clutch.
EDNY:
I have about 5 or 6 various flywheels (including new) I gathered over the years...but not sure what application they came from. I'll try to do some research tomorrow.
Had a 400 SBC flywheel in the barn....thought they were externally balanced and might work.
Ed
EDNY:
None of my flywheels would work....but there is a new one on eBay for $150 plus $32 shipping:
link:
http://www.ebay.com/itm/4-spd-NEW-454-Flywheel-Chevy-BIG-BLOCK-Chevrolet-/120407908059?pt=Motors_Car_Truck_Parts_Accessories&hash=item1c08dededb&vxp=mtr#ht_1119wt_679
Navigation
[0] Message Index
[#] Next page
Go to full version