Sorry chopper526, that I'm not up to your standards, but I do my best, I promise Thank you for the kind words, 62131, TFoch and sixball. Comments are much appreciated.Finally (again?) got the firewall done! I'm not certain about how the bottom edge needs to be done, because I don't know how to route the hoses and tubes to the heater, but I decided to do things this way, and if needed I'll make the necessary modifications later. One can't leave everything half-assed and almost-ready.So now I have someting to weld to the cowl, and to start building my floor and transmission tunnel off.The little impression or stamping a bit off center just above where the top of the transmission tunnel will be, is for the heater return hose, behind the intake. Like this:Room for a hose clamp and all now.The stamped sheet metal is from an earlier experiment, when I made a peak for the sun visor. The "tooling" is made from 5mm sheet metal, a tad more than 3/16" thick.The stamped part was cut in half and the halves were welded together. Fun to find use for a partthat wasn't used.Here's the peak I made for the visor. Quite a segway, sorry about that, it just happened.
Stats Of Website